Curtis LEDVD1966A - Manuel (Page 14)

OSD OPERATION
PC SETTINGS
Auto Adjust
Automatically adjust Clock, Phase, H-Position and V-Position settings.
In order to get a
good result, you should open a“filling the screen”picture before executing Auto Adjust.
Horizontal Position Shift the screen slightly to left or right .
Vertical Position Shift the screen slightly up or down.
Clock Adjust the DB15 picture signal sampling clock rate.
Phase Adjust the DB15 picture signal sampling phase. It maybe affect the definition .
Wrongvalue maybe result the interference.
Reset Reset the parameters of current menu to default value.
PC Settings Menu is aviliable only in PC DB15 or DVI mode. When DVI signal input,
only Horizontal Position and Vertical Position can be adjusted.
Press ▼/▲ to highlight one of the following options, then press ENTER to select it.
24
Press ▼/▲ to highlight the item and press ENTER or ►to display the sub-menu as
following.
Dynamic Contrast Off/Low/Medium/High
The system will adjust the luminance curve by analyzing the picture content
dynamically.
Film Mode Off/On
For the 2:2 or 3:2 format signal of cinema , enable special pixel process to reduce the
flick of moving area.
Noise Reduction Off/Low/Medium/High
You can clear up analog TV signal by reducing the dot noise. This feature is not
available at PC or Media source.
MPEG Noise Reduction Off/Low/Medium/High
Similar with the Noise Reduction, you can set to reduce the block noise.
25
OSD OPERATION
ADVANCED PICTURE SETTINGS
COLOR TEMPERATURE
Press ◄/► to select the Color Temperature that you feel comfortable.
Normal Basically will be accepted by most people.
Cool means a high color temperature that will feel cool.
Warm means a low color temperature that will feel warm.