Denon DRA-395 - Manuel (Page 16)

16
ENGLISH
2 Multi-source and multi-zone playback
MULTI ROOM MUSIC ENTERTAINMENT SYSTEM
• When the outputs of the MULTI SOURCE AUDIO/VIDEO OUT terminals are wired and connected to power amplifiers or TV displays installed
in other rooms, different sources can be played in rooms other than the main room in which this unit and the playback devices are installed.
(Refer to ZONE 2, 3 ROOM on the diagram.)
• When the output of the SPEAKER SYSTEM-B terminals is wired and connected to speakers in a sub room, the same source can be played in
both the main room and sub room. Set the this unit’s SPEAKER A/B selector according to the room in which the source is to be played. (Refer
to SUB ROOM on the diagram.)
• When a separately sold room-to-room remote control unit (DENON RC-616 or 617) is wired and connected between the main room, the ZONE
2/3 ROOM and the sub room, the remote-controllable devices in the main room can be controlled from the ZONE 2/3 ROOM and the sub
room using the remote control unit.
NOTE:
• Use a 75 Ω /ohms coaxial pin-plug cord for video signals to connect and wire the MULTI SOURCE VIDEO output. For the AUDIO output,
use high quality pin-plug cords and wire in such a way that there is no humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.
ZONE 2 ROOM MAIN ROOM
AMPLIFIRE TV
RC-617
DRA-395
RC-616
RC-617
SPEAKER
SYSTEM -B
ROOM-TO-ROOM REMOTE CONTROL
SYSTEM (separately sold) control line
MULTI SOURCE AUDIO signal cable
SPEAKER cable
Refer to CONNECTIONS on pages 6 and 7.
MULTI SOURCE VIDEO signal cable
(75
º / ohms)
ZONE 3 ROOM
AMPLIFIRE TV
SUB ROOM
RC-617
B
MULTI ROOM MUSIC ENTERTAINMENT SYSTEM
RC-894 (or PROGRAMABLE
REMOTE CONTROL UNIT
RC-8000)
SYSTEM REMOTE
CONTROL UNIT RC-894
RC-894 (or PROGRAMABLE
REMOTE CONTROL UNIT
RC-8000)
• Accessories
• SYSTEM REMOTE CONTROL UNIT
RC-894
• Sold Separately
• IR RETRANSMITTER RC-616
• IR SENSOR RC-617
• PROGRAMABLE REMOTE CONTROL
UNIT RC-770
With ZONE 2 ROOM and ZONE 3 ROOM multi-source playback, this unit’s MULTI SOURCE output can be controlled with the included
remote control unit.
The ZONE 2/3 mode cannot be selected from the remote control unit when the main unit is set to the REC OUT mode.
With ZONE 2/3 ROOM playback, the this unit and DENON CD players or tape decks etc, can be controlled using the included remote control
unit.
To control playback devices other than the ones above, either use that device’s remote control unit or preset a separately sold programmable
remote control unit (DENON RC-8000, etc.).
When the ZONE 2, ZONE 3 or rec out mode is set, the signal of the source selected in any mode is output for all output terminals (ZONE 2,
ZONE 3 or rec output).
RC-894 (or PROGRAMABLE
REMOTE CONTROL UNIT
RC-8000)