Maytag MVWC350WW Installation - Manuel (Page 8)

8
COMpLete INstaLLatION
CheCKLIst
When washer is level, hold the leveling foot to keep it from
turning and use a 9/16” or 14 mm open-end or adjustable
wrench to tighten jam nut (A) counterclockwise on foot
securely against washer cabinet.
HELPFUL TIP: You may want to prop washer again with
wooden block, then make sure to recheck for levelness.
Check electrical requirements. Be sure you have correct ■
electrical supply and recommended grounding method.
Check that all parts are now installed. If there is an extra ■
part, go back through steps to see what was skipped.
Check that you have all of your tools.
■
Check that yellow shipping materials were completely ■
removed from back of washer.
Check that both water faucets are on. ■
Check for leaks around faucets and inlet hoses. ■
Remove film from console and any tape remaining ■
on washer.
Check that washer is plugged into a grounded
■
3 prong outlet.
Dispose of/recycle all packaging materials. ■
Read “Washer Use” in your “Use and Care Guide”. ■
To test and clean your washer, measure 1/2 of normal ■
recommended amount of powdered or liquid detergent
and pour it into washer basket or detergent dispenser
(on some models). Close lid. Select any cycle. Start washer
and allow to complete full cycle.
19.
Tighten leveling feet
Plug into a grounded
3 prong outlet
20.
A