Danby DAC15009EE - Manuel (Page 7)

FEATURES
REMOTE CONTROL
1
2
3
4
5
6 7
8
9
10
11
12
1) ON/OFF Button: Push this button to start/stop operation.
2) MODE selection button: Each time you push this button, a mode is
selected (Auto, Cool, Dry, Heat, Fan).
3) ENERGY SAVER Button: This function is only available in COOL
mode. Push this button and the fan will continue to run for another 3
minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is above the
set temperature, at which time the cooling system turns back on.
4) TEMP/TIME Button: Push the
button to increase the indoor
temperature setting or to adjust the TIMER in a clockwise direction.
Push the
button to decrease the indoor temperature setting or to adjust
the TIMER in a counter-clockwise direction.
NOTE: Press and hold
and buttons together for 3 seconds to
alternate the temperature display between the °C and °F scales.
5) SLEEP Button: In SLEEP mode, the set temperature will increase by
2°over the next 30 minutes, and by another 2° after an additional 30
minutes. This new temperature will be maintained for 7 hours before it
returns to the originally selected temperature.
NOTE: The SLEEP mode program can be cancelled at any time during
operation by pressing the SLEEP button again.
6) Restore remote control default settings.
7) LOCK Button: When you press the LOCK button, all current settings are locked in and the remote control
does not accept any operation except that of the LOCK. Press again to cancel the LOCK mode.
8)Toggle the LED backlight on/off.
9) CLOCK Button: Used to set the time.
10) CANCEL Button:
a) If the TIMER ON, TIMER ON/OFF or TIMER OFF/ON feature has been set, pressing the CANCEL button
will override the TIMER program and turn the unit off.
b) If only the TIMER OFF feature has been set, pressing CANCEL will cancel the timer off setting and turn
on the unit (if the unit was turned off).
c) If no TIMER feature has been set, pressing the CANCEL button will do nothing.
11) TIMER Button: This button is used to preset the time ON (start operation) and the time OFF (stop
operation).
12) FAN Button: Used to select the Fan Speed; Auto, Low, Med., or High. Each time the button is pressed,
the fan speed mode is changed.
6