Maytag W10176966C - Manuel (Page 21)

Sorting
■ Separate heavily soiled items from lightly soiled ones, even if they would normally be
washed together. Separate lint-givers (towels, chenille) from lint-takers (corduroy,
synthetics, permanent press). When possible, turn lint-givers inside out.
■ Separate dark colors from light colors, colorfast items from non colorfast items.
■ Sort by fabric and construction (sturdy cottons, knits, delicate items).
Unloading
■ Remove clothes from washer after the cycle is completed. Metal objects such as zippers,
snaps, and buckles may rust if left in the washer basket for a long time.
■ When unloading garments, occasionally check under the gray colored seal at the front
of the tub for small items.
Loading suggestions
Heavy Work Clothes
4 jeans
4 work pants
4 work shirts 2 sweatpants
2 sweatshirts
Towels
1 0 bath towels 14 washcloths
1 0 hand towels
Mixed Load
3 sheets (1 king, 2 twin) g T-shirts
4 pillowcases 9 shorts
3 shirts 10 handkerchiefs
3 blouses
iCARE
Oeariirig
Cleaning the door seal
1. Open the washer door and remove any clothing or items from the washer.
2. Inspect the gray colored seal between the door opening and the basket for stained areas.
Pull back the seal to inspect areas under the seal. Remove any foreign objects.
Ifl/c fir*r
d) Wipe down area thoroughly with a dry cloth and let the washer interior air dry with
door open.
IMPORTANT:
■ Wear rubber gloves when cleaning for prolonged periods.
■ Refer to the bleach manufacturer's instructions for proper use.
Washer Maintenance Procedure
This washer has a special cycle that uses higher water volumes and steam, in combination
with AFFRESH washer cleaner or liquid chlorine bleach to thoroughly clean the inside
of the washer.
NOTES:
■ Read these instructions completely before beginning the cleaning process.
■ If necessary, the cleaning cycle may be interrupted by pressing the START/PAUSE button.
However, this will not immediately stop the cycle. The machine will display "int"
(interrupt) and continue with several rinse and drain steps to ensure that all remaining
bleach is rinsed from the washer.
A. Seal
3. If stained areas are found, wipe down these areas of the seal, using the procedure that
follows.
a) Mix a dilute solution, using V 4 cup (1 77 ml) of liquid chlorine bleach, and 1 gal.
(3.8 I.) of warm tap water.
b)
Wipe the seal area with the dilute solution, using a damp cloth.
c) Let stand .5 minutes.
21