Aqua prima” filter, Aqua, Prima – Philips 10000104 Manuel d'utilisation
Page 9: Eilter
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
“AQUA PRIMA” FILTER
To improve the quality ot the water used, install the “Aqua Prima” tilter. Atter installation, go to the
tilter initialisation program (see programming). In this mode, the machine advises the user when the
tilter must be replaced.
I
Remove the “Aqua Prima” tilter
trom its packaging. Enter the date
ot the current month.
Insert the applicator on the tilter.
Insert the tilter in its place within the
empty tank(seetigure);
Press down until it clicks into place.
Remove the tilter applicator.
Fill the tank with tresh water. Let
the tilter soak tor 30 minutes.
Atter 30 minutes discard the
water in the tank and retill with
tresh water.
Place a container under the
spout.
Press'
I
II
Press'
again.
The machine initialises the tilter.
Press^^ again.
Then, press^NU repeatedly. When the “ s x i t " message is displayed, press^^ . In this way, the machine
ends the start-up phase. Wait until at the end ot the procedure, the display shows what shown on page 8.