Levana LV-TW502 - Manuel (Page 10)

10
This is a safety notice that is aimed at educating parents and caregivers of the
potential safety hazards associated with power cords being placed too close to a crib, play
area, or other baby sleep environment. Power cords should NEVER be placed within 3 feet of a crib, or within
baby’s reach. Using Levana’s Camera Setup and Mounting Guide, you can monitor your baby while they sleep
safely in their crib.
To Mount on a Tabletop Safely (Figure A):
1. Place the camera on a tabletop at least 3 feet away from your baby’s crib.
2. Feed the power cord down the back of the table or use wall clips to secure the cord away so baby cannot
reach.
3. Plug in the power cord, check to ensure that you can see your child and there are no viewing obstructions.
To Mount on a Wall Safely (Figure B-C):
Before drilling a hole, it is important to check the reception and camera positioning in the place that you
intend on hanging it to the wall. Ensure you are hanging the camera at least 3 feet away from baby’s crib.
1. Pre-drill a hole in the wall using a 3/16", 4.8mm drill bit.
2. Insert a wall anchor into the wall and tap gently with a hammer until the anchor is flush with the wall.
3. Insert a screw into the wall anchor and tighten until the screw only sticks out about 1/2 inch.
4. Plug the power cord into the power jack of the camera.
5. Locate the wall mounting hole on the bottom of the camera.
6. Slide the hole over the screw sticking out of the wall (Figure C).
7. Check to see that the monitor is secure, if it is loose you may have to tighten the screw more.
8. Use wall clips to secure the power cord away from the crib or baby’s reach.
C B
3
ft
A
CAMERA SETUP AND MOUNTING GUIDE
For more information please visit our website at:
www.mylevana.com/SafetyInfo.html