Remove the door, Reverse the hinge and hinge cover – Kenmore ELITE HE4 110.C8586 Manuel d'utilisation

Page 11

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in

dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.

2. Move dryer into final position. Do not crush or kink vent.

Make sure dryer is level.

3. (On gas models) Check to be sure there are no kinks in the

flexible gas line.

You can change your door swing from a right-side opening to a
left-side opening, if desired.

Remove the door

Piace a towel or soft cloth on top of the dryer or work space

to protect the surface.

Open the dryer door. Remove the 4 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening last (2nd
from the top).

1

.

A. Dryer
B. Do not remove
C. Dryer door

3. Lift and puli forward on the door so that the keyhole clears

the screw head. Remove the door.

4. Lay the dryer door on a flat, protected surface with the inside

door assembly facing up. Remove the last screw from Step 2.

Remove the 6 screws to release the outer door assembly

from the inner door assembly, as indicated below. See
illustration. It is important that you remove only the
6 indicated screws.

5. Lift the inner door assembly off of the outer door assembly.

Set the outer door assembly aside.

Reverse the hinge and hinge cover
1. Place the inner door, screw head side up, on the work space.

2. Gently pull the plastic cover out and down. This unsnaps the

plastic hinge cover from the inside door assembly.

3. Remove the 4 screws that hold the hinge to the door.

4. Move the 2 large hole screw plugs to the opposite side and

insert in the original screw holes.

B

A. Hinge screws
B. Hole screw plugs

5. Move hinge to the other side and reattach with the 4 screws

removed in Step 3.

6

.

Reverse the plastic cover. Slide it up over the inner door

assembly edge and gently snap into place.

7. Set the inner door assembly aside.

11

Advertising
Ce manuel est liée aux produits suivants: