Using the rubber cushion (optional), Install trim plate, To remove the unit – Panasonic CQDF100U Manuel d'utilisation
Page 19: Cq-df100u
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
■ Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the fire wall of the car.)
Cover the Mounting Bolt (|) on the rear of the
unit with the Rubber Cushion (Optional),- and
mount it into the existing Rear Support Bracket.
3. Install Trim Plate
4. After installation, reconnect
negative (-) battery terminal.
the
Rear Support Bracket
(existing on the car)
To Remove the Unit
a) Remove the removable face plate.
(^ Page 20)
b) Remove Trim Plate (|) with a screwdriver as
shown in the figure.
©Trim Plate
c) Pull out the unit while pushing the two lock levers using the screwdriver. (• Fig. 1,2)
d) Remove the unit by pulling it with both hands. (^ Fig. 3)
Fig. 1
Lock Lever
Fig. 2
Fig.3
CQ-DF100U
19