Panasonic CQDF100U - Manuel (Page 11)

MONO/LOCAL Selection
• At the MONO setting, the amount of interference heard when
weak signals are received from an FM broadcast station is sig­
nificantly decreased.
• At the LOCAL setting, only strong signals of stations are
searched in seek turning, while at the LOCAL OFF setting, rela­
tively weak signals are also searched.
© FM broadcast
Press and hold [«jiMONO/LOC) in the tuner mode for more than
2 seconds to switch between the MONO and LOCAL modes. Each
time [*]{MONO/LOC) is pressed, the display changes as follows.
MONO OFF/LOCAL OFF ^ MONO ON/LOCAL OFF
T i
MONO OFF/LOCAL ON ^ MONO ON/LOCAL ON
© AM broadcast
Press and hold [«KMONO/LOC) for more than 2 seconds to
change the local mode as follows.
LOCAL OFF ^ LOCAL ON
Station Preset
FM1, FM2, FM3 and AM can save a maximum 6 stations each in
their preset station memories.
Manual Station Preset
© Press [BAND] to select a desired band.
©Use manual or seek tuning to find a station which is to be pre­
set in the memory.
©Press and hold one of the preset buttons [1] to [6] for more
than 2 seconds until the display blinks.
Preset number
Note: You can change the memory presetting by repeating
the above procedure.
Tuning in a Preset Station
Press the corresponding preset button [1] to [6] to tune in a preset
station.
Auto Station Preset
Select the band, press and hold [BAND](APM) for more than
2 seconds (Auto Preset Memory).
• The 6 strongest available stations will be automatically saved in
the memory on preset buttons [1] to [6].
• Once set, the preset stations are sequentially scanned for
5 seconds each.
• Press the corresponding preset button for the broadcast you
want to listen to.
Caution: To ensure safety, never attempt to preset stations while you are driving.
CQ-DF10DU
11