Installation ), Installation, Connecting procedures – Panasonic PanaSync Manuel d'utilisation

Page 10

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

( Installation )

■ Connecting Procedures

The signal cable connections differ depending what computer you are using. When connecting

to an IBM PC or PC compatible, and when connecting to an Apple computer, connect as shown

below. When connecting to any other system, please refer to that system's operating manual.

1. Please read these PanaSync P50 Operating Instructions thoroughly before installing the

P50.

2. Before connecting to a computer, always turn the computer power OFF.

3. If the computer is to be connected is an IBM compatible computer, connect the other end

of the video cable attached to the P50 nwnitor to the computer video output connector.

4. If you are using a Macintosh, please use a UNIMAC-82D Universal Mac Adapter that your

dealer can supply. (If your dealer has not supplied you a UNIMAC-82D then call 1-800-

PANASYS to obtain one.) Connect the UNIMAC-82D Adapter to the Macintosh video out­

put connector following the instructions supplied with the UN1MAC-82D. Then attach the

other ertd of the accessory video cable permanently attached to the P50 monitor to the
other side of the UNIMAC-82D attached to the Macintosh.

5. Connect the supplied P50 AC Power Cord to the P50 CEE 22 connector on the back of

the P50 and plug the other end directly Into a grounded electrical outlet.

6. Turn the P50 monitor power switch ON by pressing it once. The monitor's power indicator

will light Green or Amber.

7. Turn the computer power switch ON.
8. After booting (the PC/Mac power-up sequence and initialization) the Power LED on the

monitor should be Green. If not, check the connectors and the trouble-shooting section of

these Operating Instructions.

9. Referring to these Operating Instructions, set your desired settings.

10. When you done using the monitor, turn OFF the monitor by pressing the monitor’s Power

Switch by pressing it once. The Power LED will darken.

Caution;

The cable connectors must be securely fastened with the screws provided to prevent
accidental disconnection.

5

Advertising
Ce manuel est liée aux produits suivants: