Thetford N84 Series Installation Manual - Current - Manuel (Page 14)

Installation Manual 14
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge
[66a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the upper hinge [66b].
- Attach each of these hinges with screws.
- Put the L-shaped plastic covers over the holes that were used
by the hinges.
- Remove and save the screw [41] from the front box [68] (See
Art01573).
- Pull the front box away from the refrigerator and out from under
the controls [69].
- Reverse the front box and put it on the opposite side of the
controls.
- Attach the front box to the refrigerator with the screw.
- Put the strike plate on the opposite side of the refrigerator
[65b].
- Put the two round plastic caps into the holes that are near the
strike plate.
3. Change the position of the door handles and the door hinges
(See Art01695, Art00985, and Art00986):
- Remove the plastic cap that is opposite the upper hinge of the
upper door.
- Remove the cap screws [72] from the door handle [70] and door hinge [73].
- Remove the screws [41] and door handle from each door.
- Remove the upper hinge of each door.
- Put each of these hinges on the other side of the door as the lower hinge.
- Attach each of these hinges with the cap screws that were removed from the
other side.
- The recommended torque for each cap screw [72] is 35 in.-lbs.
- Remove the lower hinge of each door.
- Put each of these hinges on the other side of the door as the upper hinge.
- Attach each of these hinges with the cap screws that were removed from the other side.
Art01728
66a
67a
65b
66a
66b
67a
65a
67b
67b
66b
Art01573
69
41 68
Art01695
41 70
72