Thetford N84 Series Installation Manual - Current - Manuel (Page 12)

Installation Manual 12
This refrigerator has cabinet hinges that allow you to change the direction the door opens
by moving the hinges on a diagonal to the opposite side.
1. Remove the doors (See Art01726):
- Remove the storage bins from the doors.
Do not mix the upper and lower hinge pins because they are different.
- Remove and save the upper hinge pin [63] from each hinge.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [64] from each hinge.
2. Change the position of the cabinet hinges and the strike plate (See Art01728):
- Remove and save the screws from the strike plate [65a].
- Remove the two plastic hole caps that are near the strike plate.
- Remove the L-shaped plastic covers that are opposite the hinges.
- Remove and save the screws from the upper cabinet hinge
[66a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the lower hinge [66b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge
[67a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the upper hinge [67b].
- Attach each of these hinges with screws.
- Put the L-shaped plastic covers over the holes that were used
by the hinges.
- Remove and save the screw [41] from the front box [68] (See
Art01573).
- Pull the front box away from the refrigerator and out from under
the controls [69].
- Reverse the front box and put it on the opposite side of the
controls.
- Attach the front box to the refrigerator with the screw.
- Put the strike plate on the opposite side of the refrigerator
[65b].
- Put the two round plastic caps into the holes that are near the
strike plate.
66
Art01726
63
64
67
Reverse the Door Swing-Nonmetal Doors (optional)
Art01728
66a
67a
65b
66a
66b
67a
65a
67b
67b
66b
NOTICE