Krampouz Professional electric crepe maker UL - Manuel (Page 10)

- 10 -
 The appliance must not be cleaned with a high or low pressure jet.
 Do not bleach.
 Do not handle the appliance while hot.
 Do not touch the hot surfaces.
 Leave the appliance to cool prior to handling or cleaning it.
 This device is prohibited outside.
 Place the appliance on a dry and stable surface, and slightly back from the edge and at least 20 cm
from any wall or element liable to be affected by heat.
 Take care: Do not insert a sheet of tin foil or any other material or object (risk of damage) between
the plate and the frame (ventilation area).
 Do not block the ventilation holes of the plastic base, under the frame.
 Caution: Do not use this device with wood or coal to other energy source than that for which it
provides (electrical energy).
 We recommend you keep the original packaging in order to store the appliance.
KEEP THESE INSTRUCTIONS
Technical description
These models are designed for professional use.
Strong and reliable, they are convenient to use thanks to the constant temperature and even and fast
cooking.
Characteristics
 One or two crepe griddle(s) crepe maker on stainless steel frame
 Cast iron griddle  40 cm
 Power: 3750 W depending on the model
 Three elements which evenly distribute heat over the griddle
 A thermostat fitted with a control knob graduated from 50 to 300°C
 A orange indicator light to show heating period
 An On/Off switch with green light only on the following model
 Three or four plastic feet depending on the model
Instructions
Work surface
Choose an easy-to-clean work surface on which to install the appliance. The appliance must be at least
20 cm from any vertical surfaces that are not heat-resistant in order to prevent damage by heat radiating
from the plates. To ensure maximum ease of use, the top of the irons should be between 85 and 95 cm
from the ground.
Electrical connection
The appliances must be connected to the single phase 240 V network using a 16-amp two-pin plug with
earth pin. They are delivered with a power cable, type SJTOW 3 conductors (phase + neutral + earth),
cross-section 1,5 mm².