Sony MDS-JE320 Manuel d'utilisation
Page 11
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Recording on MDs
Recording Over Existing Tracks Adjusting the Recording Level
Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
KM AMS>W
a
= 0 e
mni
Do Steps 1 to 4 in "Recording on an MD" on page
6
.
When recording with INPUT at ANALOG and the
signal input through LINE (ANALOG) IN jacks, use
REC LEVEL to adjust the recording level before
starting recording.
You carmot adjust the recording level during digital
recording.
REC LEVEL
Li^
D
1 1
CD
2
Turn AMS until the number of the track to be
recorded over appears.
3
To record from the start of the track, continue
from Step 5 in "Recording on an MD" on page 7.
While 'TRACK' flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
.Ui,
^ To record from the middle of the track
1 After Step 2 above, press O- to start playback.
2
Press II where you want to start recording.
3
Continue from Step 5 in "Recording on an MD" on
page 7.
1
Do Steps 1 to 5 in "Recording on an MD" on
pages 6 and 7.
2
Play the portion of the program source with the
strongest signal level.
3
While monitoring the sound, turn REC LEVEL to
adjust the recording level so that the peak level
meters reach their highest point without turning
on the OVER indication. Occasional lighting of
"OVER" is acceptable.
4
Stop playing the program source.
5
To start recording, do the procedure starting from
Step 7 in "Recording on an MD" on page 7.
11F/V