Garland ECG SERIES ELECTRIC PRODUCTION GRIDDLES - Manuel (Page 5)

Part #3073400 (01/28/08) Page 5
INTRODUCTION
1. Damage Check: Check carton or crate for possible
damages incurred in shipping. After carefully examining,
check for “Concealed” damage. Report any damage
immediately to your carrier.
2. Any protective material covering stainless steel parts
must be removed.
3. All units are shipped from the factory with legs or casters
fitted, unless specifically ordered without.
4. The type of voltage supply that the equipment was
manufactured for at the factory is noted on the data plate
and on the packaging. This type of supply must be used.
5. Do not remove permanently affixed labels, warnings
or data plates from the appliance, for this may void
approvals and create a safety hazard.
NOTE: The griddle top is raw steel and can react with
moisture forming rust. This is normal and not considered a
defect. Clean with a stainless steel fiber pad. A light coating
of salt free oil may be applied to prevent further rusting.
Safety Concerns
This manual pertains to Electric Chain Griddles. The reader/
operator must interpret its contents to applicable needs. If
there is any question of interpretation of any of the literature
pertaining to Garland Electric Chain Griddles, please contact
your Authorized Service Agency or our Customer Service
Department at 1 800 427 6668.
A qualified person must perform the installation in
accordance with local codes.
Always follow these safety instructions when operating the
Electric Chain Griddle:
Only qualified persons must operate the unit.
Do Not operate without reading this manual.
Do Not operate the product unless it has been properly
installed and grounded.
Do Not operate the product unless all service and access
panels are in place and fastened properly.
Do Not attempt to repair or replace any part of this product
unless all main power supplies have been disconnected.
WARNING – to avoid personal injury:
Use Extreme Caution in setting up, operating and cleaning
this product to avoid coming into contact with hot grill
surfaces or hot grease. Suitable protective clothing should be
worn to prevent the risk of burns.
NOTE all warning labels and markings on the product, which
call attention to further dangers and necessary precautions.
Clearances
The space in which the appliance is to be sited must include
the minimum installation clearances shown below:
All Models
Minimum Wall Clearance
Combustible Non-Combustible
Sides 6” (152 mm) 6” (152mm)
Back 6” (152 mm) 6” (152mm)
INSTALLATION
General
1. Carefully remove the unit from the crate. All packing
material must be removed from the unit. The protective
material covering the stainless steel must be removed
immediately after the unit is installed.
2. Adequate clearance must be provided for servicing,
ventilation and proper operation. The product must be
kept clear of combustible material.