Aquascape Medium Aquabasin, Stone Fountains & Water Wall Spillway Instructions (76004, 58081, 58079, 58066) - Manuel (Page 8)

I N S T A L L A T I O N I N S T R U C T I O N S I N S T A L L A T I O N I N S T R U C T I O N S
☎ US 1-866-877-6637 | ☎ CAN 1-866-766-3426 | www.aquascapeinc.com
1. Prepare an appropriate base to lay your wall. Make sure ground is
compact and level to prevent any settling
4. Begin building the base of the back wall.
5. Center basin against back wall with bulkhead facing back. Leave an
opening in the back wall for plumbing and pump cord to pass through.
6. (a) Thread 1 ¼” MPT x 1” slip fitting on outside of bulkhead fitting
using Teflon tape (not included). (b) Cut a small piece of 1” flex PVC
and glue flex PVC into fitting in back of basin and run through opening
in wall. (c) Glue 1” elbow onto end of pipe. (d) Glue remaining flex
PVC onto elbow.
7. Build wall around front and sides of basin and continue building
back wall until desired height is reached. It is recommended to not
exceed more than a 16” overall waterfall height.
2. (a) Thread 1 ¼” MPT x 1” barbed adapter into bulkhead and
(b) attach 1” kink-free pipe. (c) Remove nut from bulkhead and place
bulkhead through the pre-drilled hole inside of the basin making sure
the rubber gasket is on the inside. (d) Thread nut onto bulkhead and
tighten using channel locks one to two turns past hand tight.
3. Place pump inside of basin and attach kink-free pipe to the
multi-hose adapter included with pump.
a.
c. d.
b.
a. b.
c. d.