Aquascape AquaBasin (98139) - Manuel (Page 4)

4
5) Now that everything is
in place, you can finish
covering the top of the
AquaBasin ™ with gravel.
(Fig. 10)
How to Hook Up a Decorative Spitter
1) The AquaBasin ™ is designed with two removable
grates for easy pump access. Connect the tubing to the
Ultra pump and ball valve using the clamps supplied from
the AquaBasin ™ Ultra ™ Pump Kit (items #98136, #98137,
or #98138 sold separately) and then place the pump and
plumbing inside the AquaBasin ™ . The cord from the pump
can be run out the notch in the side of the AquaBasin ™ .
(Fig. 6 & 7)
2) The AquaBasin ™ is designed with several holes in the
recessed area. This gives you the option of running the
tubing to the most convenient location. If you are not using
the center hole, cover it up with a few 3”-4” stones so that
smaller gravel will not fall through.
3) Next, place the spitter on the AquaBasin ™ and connect
the tubing to the spitter with the supplied clamp from the
AquaBasin ™ Ultra ™ Pump Kit (items #98136, #98137,
#98138, or #98377 sold separately). (Fig. 11) The Aqua-
Basin ™ is designed with an 18” wide recessed area in the
middle. Depending on the decorative piece being used, this
recessed area will allow you to backfill with gravel around
the decorative piece giving it a more stable platform to sit
on. It is recommended that tall or oddly
shaped pieces be set in the middle and
backfilled with gravel to prevent the
piece from falling over.
4) If you do not have to backfill around the
decorative piece simply fill the recessed
area in with gravel in order to make the
fountain level with the top of the basin.
(Fig. 7)
5) Now that everything is in place, you can
now finish covering the top of the Aqua-
Basin ™ with gravel. (Fig. 12)
Fig. 10
Fig. 13 The AquaBasin™ is designed with two supports
in the middle to help support heavier pieces.
Fig. 9
Fig. 11
Fig. 12