Pioneer DCS-340 - Manuel (Page 42)

Additional information 11
42
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the system does not operate normally due to external effects such as static electricity
disconnect the plug from the outlet and insert again to return to normal operating conditions.
General
Problem Remedy
The power does not
turn on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of wire touching the unit. This could
cause the system to shut off automatically.
No sound is output
when a function is
selected. • If you’re using the line input, make sure the component is connected
correctly (see
Connecting auxiliary components on page 29).
• Press MUTE on the remote control to turn muting off.
No image is output
when playing discs. • Make sure the TV is connected correctly (refer to the Setup Guide).
No sound from
surround or center
speakers. • Refer to Setting the channel levels on page 23 to check the speaker levels.
• Check that you haven’t selected the STEREO sound mode (see Listening in
surround sound on page 11).
• Connect the speakers properly (refer to the Setup Guide).
Can’t operate the
remote control. • Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor (refer to the Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
Timer indicator is
blinking and the
system will not switch
on. • Unplug the unit, then plug back in. Wait for one minute then switch on.
• Make sure the fan at the rear of the unit is not being blocked.
• Check that the speakers are connected correctly.
• Make sure the voltage of the mains power source is correct for the model.
• If the problem persists, take it to your nearest Pioneer authorized service
center or your dealer for servicing.
Snd Demo shows in
the display and the unit
can’t be controlled.
• Press and hold (stop) on the front panel for about five seconds. The disc
tray ejects automatically to indicate the Sound Demo mode is disabled.
XV-DV-NEW_WIZ.book 42 ページ ２００４年１２月２２日 水曜日 午後２時４１分