AEG F66600VI1P - Manuel (Page 33)

7.2 How to set an option
The option list will show only the options
applicable to the currently selected
programme. Non applicable options are
not visible.
Some options are not compatible with
each other. When you set 2 options that
are not compatible with each other, the
appliance will automatically deactivate
one of the options.
When the programme is completed or is
cancelled the options are set to the
default values.
1. Press the Option key.
2. Select an option.
The display shows the option value
indicated in parenthesis.
3. Press the OK key to change the value
from OFF to ON or vice versa.
If the selected option is Delay start, when
you press the OK key the display shows
the number of hours available for the
delay start. Select the number of hours
and press again the OK key to confirm.
4. To go back to the programme list,
press repeatedly the Option key until
the display shows the selected
programme.
7.3 Multitab
Activate this option when you use multi-
tablets that integrate the salt, rinse aid
and detergent functions. They can also
contain other cleaning or rinsing agents.
This option deactivates the release of
salt from the respective container. The
salt refilling message does not show in
the display.
With the use of this option the
programme duration is prolonged to
increase the cleaning and drying results
with the use of multi-tablets.
When you activate the option Multitab
the rinse aid dispenser continues to
release rinse aid. However you can
deactivate the rinse aid dosage by
setting the rinse aid level at 0. In this
case the drying results may not be
satisfactory.
The option Multitab is not a permanent
option and must be selected at every
cycle.
7.4 TimeSaver
This option increases the pressure and
the temperature of the water.
The washing and drying phases are
shorter. The total programme duration
decreases by approximately 50%.
The washing results are the same as with
the normal programme duration but the
drying results can be less satisfactory.
The TimeSaver option is not applicable
to all programmes.
1. Scroll through the programme list
and select a programme.
2. Press the OK key to confirm.
If the TimeSaver option is applicable to
the selected programme, the display
shows the 2 conditions Fast and Normal
and the programme duration for each
condition:
• Fast: TimeSaver activated. Press
the OK key to confirm.
• Normal: TimeSaver deactivated.
Press the OK key to confirm.
7.5 AutoOpen
This option is automatically activated
when you select the programme ECO
and it is not possible to select this option
with other programmes.
You can deactivate AutoOpen in the
option list. In this case, the energy
consumption increases.
• While the drying phase operates, a
device opens the appliance door and
keeps it ajar.
ENGLISH 33