Warning – Napoleon Fireplaces High Definition 81 - HD81 Manuel d'utilisation

Page 47

Advertising
background image

W415-0687 / G / 08.26.13

47

EN

A.

Place the door frame face down careful not to
scratch the paint.

B.

Center the gasketed glass inside the door frame
with the thick side of the gasket facing up.

C.

Bend the glass retainers located along the edge
of the door frame over the gasket holding the
glass in place. Careful not to break the glass.

!

WARNING

DO NOT USE SUBSTITUTE MATERIALS.

GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR

DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE

APPLIANCE BEFORE OPERATION.

DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS

REMOVED, CRACKED, BROKEN OR SCRATCHED.

56.1A

5.1

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.

Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

!

WARNING

6.1

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated

surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.

If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on

the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance

is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause

discolouration on plated parts.

NOTE: The protective wrap on plated parts is best removed when the assembly is at room

temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat

source.

11.6 GLASS / DOOR REPLACEMENT

11.7 CARE OF GLASS

11.8 CARE OF PLATED PARTS

GLASS

GASKET

DOOR
FRAME

GLASS
RETAINER

Advertising