Sony SA-VE100 Manuel d'utilisation

Sa-ve100, Speaker system, English precautions

Advertising
background image

}

]

}

]

}

]

}

]

}

]

}

]

]

}

MIX AUDIO

OUT

REAR

CENTER

FRONT

Speaker System

SA-VE100

English

Precautions

• Avoid driving the speaker system continuously with a

wattage exceeding the maximum input power of this
speaker system.

• Before connecting, turn off the amplifier to avoid

damaging the speaker system.

• If the +/– connection is incorrect, the bass tones seem

to be missing and the position of the instruments
becomes obscure.

In case color irregularity is observed on nearby
TV screen

With the magnetically shielded types of SS-CN17,

SS-V17 and SA-W10, the speakers can be installed near a
TV set. However color irregularity may still be observed
on the TV screen depending on the type of your TV set.

If color irregularity is observed...

n

Turn off the TV set once, then turn it on after 15 to
30 minutes.

If color irregularity is observed again...

n

Place the speakers more apart from the TV set.

Adjusting the cut-off frequency of SA-W10

When you use the superwoofer SA-W10 with SS-CN17

and SS-V17, set the CUT OFF FREQ control on the
SA-W10 within the range shown in the illustration
below.

Specifications

Speaker system

SS-CN17: Full range

×

2, magnetically shielded

SS-V17: Full range, magnetically shielded

Speaker unit

8 cm (3

1

/

4

inches, cone type)

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity

Maximum input power: 120 W

Sensitivity

SS-CN17: 89 dB (1 W, 1 m)
SS-V17: 87 dB (1 W, 1 m)

Frequency range

85 - 20,000 Hz

Dimensions

SS-CN17: Approx. 280

Ч

110

Ч

140 mm

(11

1

/

8

Ч

4

3

/

8

Ч

5

5

/

8

inches) (w/h/d)

including front grille

SS-V17: Approx. 110

Ч

160

Ч

140 mm

(4

3

/

8

Ч

6

3

/

8

Ч

5

5

/

8

inches) (w/h/d)

including front grille

Mass

SS-CN17: Approx. 1.7 kg (3 lb 11 oz)
SS-V17: Approx. 920 g / pc (2 lb)

Supplied accessories

Speaker cords (Gray)

SS-CN17:2.5 m (1)
SS-V17: 2.5 m (2) (for front speakers)

10 m (2) (for rear speakers)

Feet (4)

* As for the specifications of the SA-W10, see the

instruction manual supplied with the SA-W10.

Design and specifications are subject to change without

notice.

When connecting to speaker terminals (FRONT, REAR, CENTER, SURROUND
MIX out)

SA-W10

SS-CN17

SS-V17

(Front, R)

See the instruction manual supplied with SA-W10 for details of the
superwoofer’s connection.

Installing the speaker systems

To hang SS-V17 with a hook on the wall

To install SS-V17 with speaker stands

3-810-994-21(1)

SS-V17

(Rear, R)

AV Amplifier
etc.

SS-V17

(Front, L)

SS-V17

(Rear, L)

SA-W10

SS-CN17

SS-V17

SS-V17

To put the SS-CN17 on your TV set, attach a foot (supplied) to each bottom
corner of the speaker, and make sure that the speaker is completely flat on top
of the TV.

Feet

Hook

60mm

Nut (M5)

50Hz

200Hz

© 1996 by Sony Corporation

Printed in Malaysia

Advertising