Sony VPL-5400ES Manuel d'utilisation

Page 152

Advertising
background image

152

GB

• When using the Control for HDMI

function, you cannot control the connected
component using TV’s remote.
– Depending on the connected component

and TV, you may need to set up the
component and TV. Refer to the
operation instructions supplied with
each component and TV.

– Change the input of the receiver to the

HDMI input connected to the
component.

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure that the command modes of the

receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 108).

• Make sure you select the correct input on

the remote.

• When you operate a programmed non-

Sony component, the remote may not
function properly depending on the model
and the maker of the component.

If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.

PROTECTOR

Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of speakers and turn
on the power again.

For other messages, refer to “Message list after
auto calibration measurement” (page 53),

“XM Radio message list” (page 77), “SIRIUS
Satellite Radio message list” (page 77) a
nd
“DIGITAL MEDIA PORT message list”
(page 63).

Remote commander

Error messages

Reference sections for clearing
the memory

To clear

See

All memorized settings

page 44

Advertising
Ce manuel est liée aux produits suivants: