GE GLDT690DWW - Manuel (Page 6)

6
Installation Instruction
STEP 2 – ADJUST LEVELING LEGS
•Move the dishwasher close to the installation
location and lay it on its back.
•Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4”less than installation height.
Figure 8
Adjust to
Installation
Height
Adjust to
Installation
Height
STEP 3 – REMOVE TOEKICK
•Remove the 2 toekick screws. Lift off the 2 piece
toekick.
Figure9
2-Screws
STEP 4 – INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422and/or local
codes and ordinances.
Recommended power cord length is 54” min. and 64” max.
Connect incoming
power cord white (or ribbed)
to dishwasher white. Black
(or smooth) to black. Ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
Replace junction box cover . Be sure wires are not
pinched under the cover .
White
Ground
Black
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
Remove
Junction Box
Cover
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Use UL Listed
Wire Nuts
A
C
B
D
Figure 10
STEP 5 – INSTALL 90° ELBOW
Wrap 90 elbow with thread seal tape.
Install a 90 elbow onto the water valve.
•Do not over Tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
•Position the end of the elbow to face the rear of the
dishwasher .
Figure 11
90
Elbow
Fill
Hose
Thread
Seal Tape
Water
Valve
Bracket