JVC KD-X250BT - Manuel (Page 29)

Wiring connection
MIC
D D
(B) (A)
STEERING
WHEEL
REMOTE
D
A5
A6
A4
A7
A8
B1
B2
B3
B4
B5
B6
B7
B8 Rear speaker
(left) Green
F
Green/black G
Front speaker
(left) White F
White/black G
Front speaker
(right) Gray F
Gray/black
G
Rear speaker
(right) Purple
F
Purple/black G
Black: Earth (ground)
connection
Red: Ignition (ACC)
Orange/white: Car light control
switch
Blue/white: Remote wire
Yellow: Battery
Rear/subwoofer output
ISO connector
IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is
recommended for connection.
Custom wiring harness
(separately purchased) Custom wiring harness
(separately purchased)
If your car does NOT have an ISO terminal If your car has an ISO terminal
Modified wiring 2
or
or
Modified wiring 1
Original wiring
R: Red Y: Yellow
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
You may need to modify the wiring of the supplied
wiring harness
D as illustrated.
For some VW/Audi or Opel (Vauxhall)
automobiles
Light blue/yellow
Aerial terminal
To the steering wheel
remote control adapter
Rear ground
terminal
To Blue/white wire of
wiring harness
D
Remote wire* 1
MIC (Microphone input
terminal) (
A page 10)
10 A fuse
JVC Amplifier
Signal cord* 1
*1 Not supplied for this unit.
Installation/Connection
ENGLISHޓ| 29
2012/12/14ޓ17:11:8 KD-X250BT_E_EN