Whirlpool CT14NKXJN00 - Manuel (Page 15)

15
Style 1
To remove the plastic cover:
1. Remove crisper(s).
2. Lift cover front and remove the cover support.
3. Lift cover up and slide out.
Style 2
To remove the glass cover:
1. Pull the glass straight out.
2. Replace in reverse order.
To replace the cover:
1. Fit cover tabs into lowest cabinet slots and push in.
Lower the front retainers into place.
2. Insert cover support (with the long tab toward the front)
into the groove on the underside of the cover.
NOTE: If the support needs adjustment, turn base
clockwise to raise or counter-clockwise to lower.
Ice Maker Operation
(on some models)
After the freezer section reaches normal freezer
temperature, the ice maker fills with water and begins
forming ice. Allow 24 hours to produce the first batch of
ice. Ice maker should then produce approximately 7 to 9
batches of ice in a 24-hour period. Discard the first three
batches of ice produced to avoid impurities that may be
flushed out of the system.
After ice is made, the ice cubes drop into the storage bin.
When ice storage bin is full, ice maker arm raises to the
“OFF” position (arm up). If ice is not needed, you can stop
the ice maker by raising the arm to the “OFF” position (arm
up). Listen for a click sound to be sure that the ice maker
will not continue to operate.
To start ice maker, lower arm to the “ON” position (arm
down). Do not force arm up or down. Do not store anything
on top of the ice maker or in the ice storage bin.
■ The ON/OFF lever for the ice maker is a wire signal arm
located on the side of the ice maker. Push the arm
down to start making ice automatically, and push it up
to shut off the ice maker.
■ It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
■ The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as
overnight.
■ If you remove the ice bin, raise the signal arm to shut
off the ice maker. When you replace the bin, push it in
all the way and lower the ice maker signal arm to the
“ON” position.
REMEMBER:
■ The quality of your ice will be only as good as the
quality of the water supplied to your ice maker.
■ Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and
is well maintained.