For u.s.a – Teac SR-L35CD Manuel d'utilisation

Page 3

Advertising
background image

ENGLISH

3

For U.S.A.

Optical pickup :

Type

: CMS-M95BG6

Manufacturer : SAMSUNG
Laser output

: 0.5mW on the objective lens

Wavelength

: 760 - 800 nm

(rear panel of the unit)

CAUTION

<

DO NOT REMOVE THE EXTERNAL CASES OR
CABINETS TO EXPOSE THE ELECTRONICS. NO USER
SERVICEABLE PARTS ARE WITHIN!

<

IF YOU ARE EXPERIENCING PROBLEMS WITH THIS
PRODUCT, CONTACT TEAC FOR A SERVICE
REFERRAL. DO NOT USE THE PRODUCT UNTIL IT
HAS BEEN REPAIRED.

<

USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.

WARNING : TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.

This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:

• Reorient or relocate the equipment and/or the

receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the receiver is
connected.

• Consult the dealer or an experienced radio/TV

technician for help.

CAUTION

Changes or modifications to this equipments not
expressly approved by TEAC CORPORATION for
compliance will void the user’s warranty.

For U.S.A.

This product has been designed and manufactured
according to FDA regulations “title 21, CFR, chapter 1,
subchapter J, based on the Radiation Control for
Health and Safety Act of 1968“, and is classified as
class 1 laser product. There is not hazardous invisible
laser radiation during operation because invisible laser
radiation emitted inside of this product is completely
confined in the protective housings.
The label required in this regulation is shown

.

Advertising