Pioneer DEH-P6400 - Manuel (Page 13)

Tuner
En 13
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 14.
1
STEREO ( ST ) indicator
Shows that the frequency selected is being
broadcast in stereo.
2
BAND indicator
Shows which band the radio is tuned to, AM
or FM.
3
PRESET NUMBER indicator
Shows what preset has been selected.
4
FREQUENCY indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner .
Press SOURCE until you see Tuner displayed.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND/ESC to select a band .
Press BAND/ESC until the desired band is dis-
played, FM1 , FM2 , FM3 for FM or AM .
4 To perform manual tuning, press
2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold
2
or
3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold
2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the STEREO ( ST ) indicator will
light.
1 2 3
4
English
Español
Deutsch
F
rançais
Italiano
Nederlands
03
Section