Pioneer SX-SW260 - Manuel (Page 7)

Speaker Setup Guide 01
7
En
English
Chapter 1
Speaker Setup Guide
Safety precautions when setting up
When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.
Home theater sound setup
Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system.
Standard surround setup
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
1 Attach the smaller non-skid pads to the base of
each of the front, surround and center speakers. The
four large non-skid pads are for the receiver
subwoofer (as shown).
Use the adhesive side of the pads to attach them to the
base (flat surface) of each speaker.
2 Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram (left) for optimal surround sound.
After placing the speakers, run the Auto MCACC setup
(page 17) to complete your surround sound setup.
Receiver subwoofer
Front
left
Surround
left
Listening position
Center
Listening position
Front
right
Surround
right
Non-skid pads
(small) x 20
Front and surround speakers
Center speaker
Non-skid pads
(large) x 4
Receiver subwoofer
SX-SW260_KU.book Page 7 Wednesday, March 29, 2006 2:43 PM