Pioneer HTZ-360DV - Manuel (Page 33)

Other connections 08
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Connecting using HDMI
If you have a HDMI or DVI (with HDCP)
equipped monitor or display, you can connect
it to this player using a commercially available
HDMI cable for high quality digital video.
1
See About HDMI below for more about the
HDMI connection.
• Use an HDMI cable to connect the HDMI
OUT interconnect on this player to an HDMI
interconnect on a HDMI-compatible monitor.
• The arrow on the cable connector body
should be face up for correct alignment
with the connector on the player.
You can also adjust the HDMI settings for
resolution and color. For more on these
settings see
Video Output settings on page 26.
Switching the HDMI audio setting
To listen to audio from the HDMI interconnect,
make sure you’ve specified the HDMI audio
output setting.
1 Switch the system into standby.
2 Press SETUP and use / to choose
HDMI OUT then press ENTER .
3 Use / to choose the setting you want
then press ENTER .
• AUDIO ON – Audio signals are output
through the HDMI interconnect
• AUDIO OFF – Switches off HDMI audio
Resetting the HDMI connection
If you get an error message (the display shows
HDMI ERR ) or if the screen goes blank (for
example, after changing the resolution), check
the troubleshooting guide on page 42. If this
doesn’t solve the problem, follow the steps
below to reset the HDMI connection.
1 Switch the system into standby.
2 Press SETUP and use / to choose
HDMI INI then press ENTER .
The system will restart and the HDMI settings
are automatically reset to the factory defaults.
See
Video Output settings on page 26 for more
on these settings.
Note
1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth Dig-
ital Content Protection (HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVI
HDMI) to
do so. A DVI connection, however, does not support audio signals. Consult your local audio dealer for more information.
• This unit has been designed to be compliant with HDMI (High Definition Multimedia Interface) Version 1.1. Depending on
the component you have connected, using a DVI connection may result in unreliable signal transfers.
• When you change the component connected to the HDMI output, you will also need to change the HDMI settings to match
the new component (see Video Output settings on page 26 to do this).
AM LOOP
FM
UNBAL 75 Ω
R
L
R L
FRONT CENTER
SURROUND SUB WOOFER
R L
S-VIDEO
VIDEO
COMPONENT VIDEO
C R / P R
C B /
P B
Y
ANTENNA
AUDIO IN
LINE
SPEAKERS VIDEO OUT HDMI OUT HDMI OUT
HDMI-compatible display
HDMI
connector
Other connections.fm 33 ページ ２００６年２月２７日 月曜日 午後６時１１分