Pioneer VSX-816 - Manuel (Page 10)

Quick surround sound setup 03
10
En
6 Follow the instructions on-screen.
• Make sure the microphone is connected.
• If you’re using a subwoofer, it is
automatically detected every time you
switch on the system. Make sure it is on
and the volume is turned up.
• See below for notes regarding background
noise and other possible interference.
7 Wait for the test tones to finish.
A progress report is displayed on-screen while
the receiver outputs test tones to determine
the speakers present in your setup. Try to be as
quiet as possible while it’s doing this.
• For correct speaker settings, do not adjust
the volume during the test tones.
8 Confirm the speaker configuration.
The configuration shown on-screen should
reflect the actual speakers you have.
If the speaker configuration displayed isn’t
correct, use
/ to select the speaker and /
to change the setting (and number for
surround back). When you’re finished, go to
the next step.
If you see an error message ( ERR ) in the right
side column, there may be a problem with the
speaker connection. If selecting
RETRY
doesn’t fix the problem, turn off the power and
check the speaker connections.
9 Make sure ‘OK’ is selected, then press
ENTER.
A progress report is displayed on-screen while
the receiver outputs more test tones to
determine the optimum receiver settings for
channel level, speaker distance, and Acoustic
Calibration EQ.
Again, try to be as quiet as possible while this
is happening. It may take 3–8 minutes.
10 The Auto MCACC Setup has finished!
Select ‘SKIP’ to go back to the System Setup
menu.
The MCACC indicator on the front panel will
light to show the setup is complete.
The settings made in the Auto MCACC Setup
should give you excellent surround sound from
your system, but it is also possible to adjust
these settings manually using the System
Setup menu (starting on page 34). 1
You can also choose to view the settings by
selecting individual parameters from the
Analyzed Data Check screen:
• Speaker Setting – The size and number of
speakers you’ve connected (see page 40
for more on this)
• Speaker Distance – The distance of your
speakers from the listening position (see
page 42 for more on this)
2.Auto MCACC
Now Analyzing
Environment Check
Ambient Noise
[ O K ]
Microphone [ ]
Speaker YES/NO [ ]
:Cancel
O K
O K
2.Auto MCACC
CHECK!
Front [ YES ]
Center [ YES ]
Surround [ YES ]
SB [ Yx2 ]
SUB W.
[ YES ]
OK
:Cancel
Note
1 • Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 5 inches (12cm)
will end up with different size settings. You can correct the setting manually using the
Speaker Setting on page 40.
• The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be
accurate (taking delay and room characteristics into account) and generally does not need to be changed.
2.Auto MCACC
Now Analyzing
Surround Analyzing
Speaker System
[ ]
Speaker Distance [ ]
Channel Level
[ ]
Acoustic Cal EQ [ ]
:Cancel
VSX_816.book.fm 10 ページ ２００５年１２月８日 木曜日 午後６時５４分