Pioneer Blu-ray 3D Player BDP-52FD - Manuel (Page 21)

21
En
02
Connecting video and
audio cables
Note
• Make the settings in the Setup Navigator menu
according to the type of cable connected (page 24).
• To output video signals from this player, connect
using a video cable (not including when connected
using an HDMI cable).
Connecting a TV using a
video/audio cable
Caution
• Connect the player’s video output directly to
your TV.
This player supports the analog copy protection
technology. Therefore, the picture may not be
displayed properly if this player is connected to a TV
via a DVD recorder/video deck or when playing the
player’s output material that is recorded by a DVD
recorder/video deck. Furthermore, the picture may
not be displayed properly due to the copy protection
when the player is connected to a TV with a built-in
video deck. For details, contact the manufacturer of
your TV.
Note
• Video signals are output with a resolution of 480/576I
or 480/576P when this player is connected using a
video cable.
• Depending on the output video resolution setting, the
picture may not be output.
Connecting an AV receiver or
amplifier using an optical
digital audio cable
Note
• To switch the video from the AV receiver or amplifier,
also connect the video output terminals.
Connecting
components to the
USB port
The data downloaded with the BD-LIVE function and the
data used with the BONUSVIEW function when playing
BD-ROMs can be stored on a device connected to the
USB port (USB memory).
About USB memory devices
The USB memory devices that can be connected to the
player are as shown below.
• USB 2.0-compatible memory devices
• FAT16 or FAT32 file system, minimum 1 GB capacity
(2 GB or more recommended)
Note
• Devices formatted with a file system other than the
above cannot be used. Such devices may however be
usable if they are formatted from the player.
• USB memory devices may not be recognized if they
contain multiple partitions.
• Some USB memory devices may not operate with this
player.
• Operation of USB memory devices is not guaranteed.
TV
BDP-53FD’s rear panel
Direction of
signal flow
White
Red
It is also possible to connect to
an AV receiver or amplifier.
Connect the audio signals using
an optical digital audio cable or
an audio cable (2 channels) (on
the right column).
To video/audio input terminals
Vi
deo
/au
di
o
c
a
bl
e (in
c
lud
e
d)
Yellow
BDP-53FD’s rear panel
To audio input terminals
AV receiver or
amplifier Direction of signal flow
2-channel analog
audio can also be
connected.
To optical digital
audio input terminal
Optical digital audio
cable (commercially
available)
White
Red
Video/audio cable
(included)
BDP-52FD_UCXCNSM_IBD_EN.book Page 21 Friday, September 30, 2011 9:59 AM