Keurig B155 - Manuel (Page 16)

16
using the two front ribs as a guide, and snap
them into place from the top.
2. Cleaning the Funnel — The Funnel can be
removed from the K-Cup ® Pack Holder by
pulling on it until it pops off (fig. 24). The Funnel
is dishwasher safe. To replace it, just snap it
back onto the K-Cup
® Pack Holder.
3. Cleaning the Exit Needle — The Exit Needle
is located on the inside bottom of the K-Cup ®
Pack Holder. Should a clog arise due to coffee
grinds, it can be cleaned using a paper clip
or similar tool. Remove the K-Cup
® Pack Holder
Assembly and detach Funnel. Insert the
paper clip (as shown in fig. 24) into the
Needle to loosen the clog, then flush
with water. The K-Cup ® Pack Holder Assembly
can be placed onto the top shelf of a dishwasher.
NOTE: Use low temperature cycles in the
dishwasher.
CAUTION: There are sharp needles that puncture the K-Cup ® pack above the
K-Cup ® Pack Holder and in the bottom of the K-Cup ® Pack Holder. To avoid
risk of injury, do not put your fingers in the K-Cup ® Pack Assembly Housing.
SECTION 3 Cleaning & Maintenance (continued)
!
fig. 24
Cleaning the Water Reservoir & Water Reservoir Lid
The Water Reservoir Lid or Water Reservoir should not be put into the
dishwasher. They should be cleaned with a damp, soapy, non-abrasive cloth
and rinsed thoroughly. Do not dry the inside of the Water Reservoir with a
cloth as lint may remain.
CAUTION: Please rinse the Water Reservoir
thoroughly after cleaning to ensure that no cleaners or cleaning solutions
remain in this area as they may contaminate the water supply in the Brewer.
De-Scaling Your Brewer
Mineral content in water varies from place to place. Depending on the mineral
content of the water in your area, calcium deposits or scale may build up in
your Brewer. Scale is non-toxic, but left unattended, it can hinder Brewer
performance. De-scaling your Brewer helps maintain the heating element
and other internal parts of the Brewer that come in contact with water.
The Brewer should be de-scaled every 3-6 months to ensure optimal
performance. It is possible for calcium deposits to build up faster, making it
necessary to de-scale more often.