Sony TA-VE910 - Manuel (Page 9)

9 EN
Getting Started Getting Started
Digital Component Hookups
Overview
This section describes how to connect an LD player,
DAT/MD deck, and CD player equipped with digital
jack(s) to the amplifier. If you use a digital component,
select the appropriate input mode for the component
(see page 11).
WIRELESS REAR
SPEAKER
FRONT SPEAKERS
A
R
B
A
L
B
SURROUND SPEAKERS
IMPEDANCE USE 4–16 Ω
REAR
IMPEDANCE USE 4–16 Ω
+
–
+ + – –
+ + – –
+
–
R
R
WOOFER AUDIO OUT
VIDEO OUT
OUT IN IN OUT
VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN
IN
L
R
RECOUT IN IN IN
AUDIO IN
L
R
AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN
PHONO DAT / MD
MONITOR VIDEO 1 VIDEO 2 LD
L
L
CENTER
VIDEO IN
AUDIO IN
TV
AC OUTLET
SWITCHED 100W MAX
TUNER CD
IN RECOUT
TAPE
SIGNAL GND
y
LD IN
LD IN
LD IN
AC-3 RF
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
COAXIAL
DIGITAL
LD IN AC-3 RF/
OPTICAL
LD IN
COAXIAL DAT/MD IN/OUT
OPTICAL
CD IN OPTICAL
What cords will I need?
• Optical digital connecting cord (not supplied) (1 for an LD
or CD player; 2 for a DAT or MD deck)
• Coaxial digital connecting cord (not supplied) (1 for an LD
player)
Hookups
The arrow ç indicates signal flow.
LD player
Connect the LD player either to the LD IN COAXIAL or
OPTICAL jack.
LD player Amplifier LD player
З
з
DIGITAL
OUT LD IN
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
COAXIAL
DIGITAL
DIGITAL
OPTICAL COAXIAL
OUT
AC-3 RF
LD IN
If your LD player has an RF output jack, connect it to the LD
IN AC-3 RF jack of the amplifier as shown below.
Amplifier LD player
Ç
AC-3
RF
OUT LD IN
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
COAXIAL
DIGITAL
AC-3 RF
LD IN
CD player
Amplifier CD player
Ç
DIGITAL
OUT LD IN
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
COAXIAL
DIGITAL
AC-3 RF
LD IN
DAT or MD deck
Amplifier DAT or MD deck
X з
З
DIGITAL
OUT IN LD IN
LD IN
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
COAXIAL
DIGITAL
AC-3 RF
Warning regarding the playback of DAT/MD sources
When playing DAT/MD sources through the amplifier,
do not play a DAT/MD that contains digital recordings
made from a DVD player whose digital output was set
to “DOLBY DIGITAL.” High volume noise will be
output which may damage the amplifier and your
speakers.
Notes
• This amplifier is compatible only with digital components
using 32, 44.1, or 48-kHz sampling frequencies and not
compatible with 96 kHz.
• Be sure to connect digital components (CD player, DAT/
MD deck, etc.) to the analog jacks as well as the digital
jacks in order to do analog recording.