JVC DLA-M20U - Manuel (Page 27)

26
Basic Operations
■ Projector’s buttons
■ Remote control unit
MAIN POWER switch
The following describes the basic procedure for normal use of
the projector.
1 Turn on the MAIN POWER
switch.
ON [ ❙ ]:The main power turns on and the STAND BY
indicator comes on.
Projector’s indicator
2 Press the OPERATE button for
one second or more.
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Notes
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
• If the light-source lamp does not light up, try to press the OPERATE
button for more than a second again.
■ Turning off the Power
1 Press the OPERATE button for
one second or more.
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
2 Turn off the MAIN POWER switch
after the STAND BY indicator
changes to steady on.
OFF [ ‡ ‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
2 , 1
1 , 2
Remote control unit
Projector
or
Example of the projector’s button Projector
Projector
2 , 1
1. Turning on the Power
\
STAND BY
(ON)
OPERATE
(ON)
OPERATE
(ON)
OPERATE
STAND BY
(Blinking)
STAND BY
(OFF)
STAND BY indicator
OPERATE indicator
OPERATE button
ST AND BY OPERA TE LAMP TEMP EMERGENCY
STAND BY
LAMP
TEMP
EMERGENCY
VIDEO
COMPUTER
SETTING
QUICK
ALIGN.
- 2
+ 3
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). Turn it
off after the STAND BY indicator becomes on (stand-
by mode).
OPERATE
VOL.
PAGE
BACK
PRESET
FOCUS
COMPUTER VIDEO
QUICK
ALIGN. AV
MUTING
MENU/ENTER
ZOOM
T
W
OPERATE button
M20U p.24-34 00.6.15, 8:18 PM 26