John Deere AC-3000EH-3 - Manuel (Page 7)

John Deere Operator's Manual 7
RISK OF BODILY INJURY Serious injury or death may occur
from detergents contacting the
skin.
SEEK EMERGENCY MEDICAL CARE if you are
using cleaning agents and the spray appears to
have penetrated the skin! DO NOT TREAT AS
A SIMPLE CUT! Be prepared to tell a physician
exactly what kind of detergents you were using by
reading the Material Safety Data Sheet (MSDS)
provided with your detergent.
Never use any solvents or highly corrosive
detergents or acid type cleaners with this pressure
washer.
Protective equipment such as rubber suits, gloves
and respirators are advisable, especially when
using cleaning detergents.
Keep all detergents out of the reach of children!
ALWAYS wear protective goggles when operating
the unit to shield the eyes from flying debris and
detergents.
DO NOT direct spray toward fragile materials such
as glass for shattering could occur.
If the pressure washer is equipped with an Auto
start/stop feature, the unit will shutdown until
the gun is triggered. To prevent accidental high
pressure discharge, do not leave unit unattended
while in this mode.
Stay alert-watch what you are doing. Do not
operate the unit when fatigued or under the
influence of alcohol or drugs.
NEVER squeeze the trigger unless securely
braced.
DO NOT overreach or stand on unstable support.
Keep good footing and balance at all times.
Wet surfaces can be slippery, wear protective
foot gear and keep good footing and balance at
all times.
NEVER trigger the gun while on a ladder or
roof.
ALWAYS hold on firmly to the gun/lance assembly
when starting and operating the unit. Failure
to do so can cause the lance to fall and whip
dangerously.
Know how to stop the pressure washer and bleed
pressures quickly. Be thoroughly familiar with
controls.
DO NOT leave pressurized unit unattended. Shut
off the pressure washer and release trapped
pressure before leaving.
DO NOT operate the unit if you see any fuel, oil or
water leaks from the machine. DO NOT resume
operation until the unit has been inspected and
repaired by a qualified service person.
Place unit in a clean, dry, flat area for servicing.
Before servicing the unit: turn the unit off, relieve
the water pressure from the trigger gun, and allow
the unit to cool down. Service in clean, dry, flat
area. If applicable, block wheels to prevent unit
from moving.
Do not move the unit by pulling on the hose.
!SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
READ ALL SAFETY INSTRUCTIONS BEFORE USING PRESSURE WASHER
POTENTIAL CONSEQUENCE PREVENTION HAZARD
Serious injury can occur from
loose debris being propelled at a
high speed from the spray gun.
Injury may occur if the operator
loses his balance caused by the
thrust of water traveling through
the spray nozzle.
Injury may occur from the
pressure washer.