John Deere T165 - Manuel (Page 27)

107351-01C
Assembly
ATTACHING HEATER AND HANDLES
1. Install heater assembly (A) to wheel support
frame (B). Align holes in heater assembly and wheel
support frame.
Note: Wheels are to be at hot air outlet end of heater
on T70 ONLY (see next picture below).
2. Install fuel gauge cap (C).
3. Install rear handle (A) using screws (B) and
lock nuts (C). DO NOT TIGHTEN.
4. Install front handle (A) (excluding T70) using
screw (B) and lock nuts (C) DO NOT TIGHTEN.
5. Tighten all screws and nuts.
23
Model T70 Shown
B
A
C
B
A
B
C
A
C