John Deere T165 - Manuel (Page 19)

107351-01C
Periodic Service
CLEANING FLAME SENSOR
1. Remove upper shell (A) from heater by remov-
ing self-tapping screws.
Note: Nose Cone Guard must be removed first on
model T70.
IMPORTANT: DO NOT bend flame sensor mounting
bracket.
2. Remove sensor (A) from bracket (B) and clean
face of photocell with a soft cloth.
3. Insert sensor into bracket.
4. Install upper shell.
CLEANING AIR INTAKE FILTER
1. Remove upper shell and plastic fan guard.
2. Remove filter (A) from filter cover (B).
3. Clean filter in mild detergent and warm water.
Dry thoroughly before reinstallation. Replace if
needed.
IMPORTANT: DO NOT oil filter or pump.
There are two other filters inside the pump assembly;
an air output filter and a lint filter. See your John Deere
dealer for service.
15
A
B
A
A
B