JVC RC-EX30BC - Manuel (Page 16)

13
English
Programmed playback
Up to 40 tracks can be programmed to play in any desired order.
PUSH
PLA Y/P AU SE
ST OP
PROGRAM/ CLOCK SET
HBS/ PRESET EQ
DISPLAY
TA PE
CD
BAND
RANDOM
TUNER
GR OUP
REMOTE SENSOR
PRESET UP
PRESE T DOWN
TAPE
FM MODE /BEAT CUT
PROGRAM/
CLOCK SET UP
DOWN
INTRO
HBS/ PRESET EQ
REPEAT
STANDBY/ON
DISPLAY
MUTING PRESET
VOLUME
RM-SRCEX30J REMOTE CONTROL
1 2 3
4 5 6
7 8 9
0 OVER
CD/ RANDOM TUNER/ BAND
GROUP
+
–
3,5 6 3 6 2,4,5 1 3 1 2,4,5
1 Press CD/RANDOM to enter CD mode, if the unit
is in TUNER or TAPE mode.
You can press CD/RANDOM on the remote control
unit to enter CD mode.
2 Press PROGRAM/CLOCK SET in stop mode.
The PROGRAM indicator appears in the display
window.
PROGRAM
3 Press 4 or ¢ to select a desired track to be
programmed.
You can use the number buttons on the remote control
unit to select a desired track.
PROGRAM
Track to be programmed
4 Press PROGRAM/CLOCK SET.
5 Repeat steps 3 and 4 to program other tracks.
6 Press PLAY/PAUSE 3/8.
The tracks are played in the order you have
programmed.
You can press
3/8 on the remote control unit to start
programmed playback.
Note:
If you press CD/RANDOM while in CD mode, the unit
enters the random playback mode.
To check the program contents
Press PROGRAM/CLOCK SET repeatedly in stop mode
when “PROGRAM” is displayed.
Each time you press the button, the program number and
the corresponding track number are shown in the display
window.
To add tracks in the program
1 Press PROGRAM/CLOCK SET repeatedly in stop
mode when “PROGRAM” is displayed so that the
track number “0” is shown.
2 Press 4 or ¢ (or use the number buttons on
the remote control unit) to select the track number
to be added, then press PROGRAM/CLOCK SET.
To edit the program
1 Press PROGRAM/CLOCK SET in stop mode
when “PROGRAM” is displayed so that the
program number you want to edit is shown.
2 Press 4 or ¢ (or use the number buttons on
the remote control unit) to select a new track
number, then press PROGRAM/CLOCK SET.
To repeat programmed playback
Press REPEAT on the remote control unit after starting
programmed playback.
To erase the entire program in the memory
Press STOP 7 (or 7 on the remote control unit) in stop
mode when “PROGRAM” is displayed.
The program is cleared, and the PROGRAM indicator
goes off.
The program is also cleared when you open the disc door,
turn off the unit or change to other audio sources.
Note:
You cannot program more than 40 tracks.
“– – FULL – –” is displayed when you try to program
the 41st track.
02_01-23_RC-EX30B_C_En.p65 04.8.17, 0:46 PM 13