JVC RC-EX30BC - Manuel (Page 10)

7
English
SETTING THE CLOCK
PUSH
PLA Y/P AUSE
ST OP
PROGRAM/ CLOCK SET
HBS/ PRESET EQ
DISPLAY
TA PE
CD
BAND
RANDOM
TUNER
GR OU P
REMOTE SENSOR
PRESET UP
PRESET DOWN
TAPE
FM MODE /BEAT CUT
PROGRAM/
CLOCK SET UP
DOWN
INTRO
HBS/ PRESET EQ
REPEAT
STANDBY/ON
DISPLAY
MUTING PRESET
VOLUME
RM-SRCEX30J REMOTE CONTROL
1 2 3
4 5 6
7 8 9
0 OVER
CD/ RANDOM TUNER/ BAND
GROUP
+
–
2,3,4 3,4 2,3,4 3,4 1 1
Before operating the unit any further, first set the clock
built in this unit.
The clock uses 12-hour indication. “AM 12:00” indicates
midnight, and “PM 12:00” indicates noon.
1 Press STANDBY/ON to turn off the unit, if it
is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK SET for more
than 2 seconds.
The hour digits start flashing.
3 Press 4 or ¢ to adjust the hour, then press
PROGRAM/CLOCK SET.
The minute digits start flashing.
4 Press 4 or ¢ to adjust the minutes, then press
PROGRAM/CLOCK SET.
Note:
If there is a power failure, the clock loses the setting and
is reset to “AM 12:00.” The clock indication will keep
flashing until you set the clock again.
To show the clock when the unit is on
Press DISPLAY.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
DISPLAY
DISPLAY
Main unit Remote
Note:
Operating the unit while clock indication is displayed
changes the display to the normal indication.
02_01-23_RC-EX30B_C_En.p65 04.8.17, 0:46 PM 7