Maytag W10312954A - Manuel (Page 7)

7
led diSPlAY ANd SeTTiNGS bUTTONS
When you select a cycle, its default settings will light up
and the Estimated Time Remaining (for Sensor Cycles) or
actual time remaining (for Timed Cycles) will be displayed.
Use the buttons along the bottom of the display to adjust
settings. See Cycle Guide for available settings on each
cycle. Not all settings are available with all cycles.
Cycle Status lights
The indicator bar at the top of the display will let you
know what stage of the drying cycle is in process. For
more information on each stage, see “Cycle Status
Indicators”.
Temp level
When using Timed Cycles or Auto Refresh, you may
select a dry temperature based on the type of load
you are drying. Use the warmest setting safe for the
garments in the load. Follow garment label instructions.
NOTe: Sensor Cycles use a preset temperature that is
not adjustable.
dryness level
You may adjust the Dryness Level on Sensor Cycles,
if desired.
NOTe: Dryness Level is for use with Sensor
Cycles only.
damp Signal
When selected, a signal will sound during the drying
cycle when the load is damp but not completely dry.
This will allow you to take clothes out of the load that
do not need to dry completely. This option is available
on Heavy Duty, Normal, Denim, Bedding, Wrinkle
Control, and Delicate cycles.
5 6
7
8
OPTiON bUTTONS
Use these buttons to select available options for your
dryer. Not all cycles and options are available on all
models.
Wrinkle Prevent/Wrinkle Prevent with Steam
(on some models)
If you will be unable to remove a load immediately,
press Wrinkle Prevent to add up to 150 minutes of
periodic tumbling to help reduce wrinkling. On models
with Wrinkle Prevent with Steam, a short steam cycle is
added after 60 minutes to help smooth out wrinkles.
NOTe: On models with Wrinkle Prevent with Steam,
you may turn off Steam by pressing and holding the
Wrinkle Prevent button until - St appears in the display.
The dryer will remember this setting for future loads.
To turn Steam back on, press and hold the Wrinkle
Prevent button again for several seconds.
drum light
Press to turn the LED drum light on or off. The light
will also turn on when the door is open, and turn off
automatically after about 5 minutes.
Cycle Signal
Use this button to turn the signal indicating the
end of a drying cycle on or off, or to adjust the
volume of the signal.
NOTe: You may also turn off the tones that sound
when a button is pressed. Press and hold the
Cycle Signal button for about one second to turn
button sounds on or off.
Control lock
Use this button to lock the controls of the dryer
and avoid an accidental change in cycle options or
preferences during a drying cycle.
redUCe STATiC (on some models)
Press to add the Reduce Static option to a Sensor cycle.
The dryer will automatically tumble, pause, and introduce
a small amount of moisture into the load to help reduce
static. This option adds approximately 8 minutes to the
total cycle time.
STeAM bOOST (on some models)
Steam Boost adds steam to the end of the Heavy Duty,
Bedding, Normal, or Denim cycle to help smooth wrinkles.
Steam Boost can be used with High or Medium heat
settings.