Maytag W10312954A - Manuel (Page 11)

11
7.
Press and hold STArT/PAUSe
to begin cycle
Press and hold the START/PAUSE button to begin the cycle.
+
-
temp level dryness level damp signal
8.
remove garments promptly
after cycle is finished
Promptly remove garments after cycle
has completed to reduce wrinkling. If
you will be unable to remove the load
promptly, select the Wrinkle Prevent/Wrinkle Prevent with
Steam option before pressing START/PAUSE.
+
-
temp level dryness level damp signal
5.
Adjust cycle settings, if desired
You may adjust different settings, depending on whether you
have selected a Sensor Cycle, Timed Cycle, or Steam Cycle.
See the Cycle Guide for detailed information.
NOTe: Not all options and settings are available with all cycles.
Not all cycles are on all models.
Sensor Cycles:
You can select a different dryness level, depending on your
load, by pressing the button for More, Normal, or Less.
Selecting More, Normal, or Less automatically adjusts the
dryness level at which the dryer will shut off. Once a dryness
level is set, it cannot be changed without stopping the cycle.
Sensor cycles give the best drying in the shortest time.
Drying time varies based on fabric type, load size, and
dryness setting.
Timed Cycles:
When you select a Timed Cycle, the default
time appears in the display. Use the + and -
buttons to increase or decrease the time in
1 minute increments. Press and hold to
change the time in 5 minute increments.
The default temperature may be changed
by pressing the Temp Level button until the
desired dry temperature is lit.
Custom refresh with Steam:
The cycle time defaults to 15 minutes, for 1-4 items.
For larger loads, you may add additional time up to 50 minutes,
in 5 minute increments, using the Timed Dry Adjust + and -
buttons.
6.
Select any additional options
Add additional options such as Reduce Static, Wrinkle Prevent/
Wrinkle Prevent with Steam and/or Steam Boost by pressing
the button for that option.
NOTe: Not all options and settings are available with all cycles.
wrinkle
prevent
without steam
11-cycle model shown
11-cycle model shown
+
-
temp level dryness leve
11-cycle model shown
Changing the Sensor Cycle settings
to increase drying time
If all your loads on all Sensor Cycles are consistently not
as dry as you would like, you may change the default
settings to increase the default dryness level.
Your sensor drying settings can be adjusted to adapt to
different installations, environmental conditions or personal
preference. This change is retained and will affect all of your
sensor cycles, not just the current cycle/load. There are 3
drying settings, which are displayed using the time display:
01 Factory preset dryness level.
02 Slightly drier clothes, 15% more drying time.
03 Much drier clothes, 30% more drying time.
To change the drying settings:
NOTe: The settings cannot be changed while the dryer is
running or paused. The dryer must be in standby mode (the
power button is off) to adjust the default settings.
1. Before starting a cycle, press and hold the Temp Level
button for 6 seconds.
2. Press the Dryness Level button to select the dryness
level shown in the time display: 01, 02, or 03.
3. Press START/PAUSE to save the new dryness level
setting.