Maytag W10312954A - Manuel (Page 12)

12
ADDITIONAL FEATURES
2. Align the two hooks on the front of the drying rack with
the holes in the dryer door opening and press down fully
into holes. Rest the rear support on the dryer back ledge.
USiNG THe drYiNG rACK
To obtain a drying rack for your dryer, follow the instructions
included in your dryer drum. Remove and discard any
packing material before use.
Use the Drying Rack for items that you do not want to
tumble dry, such as sweaters and tennis shoes. When you
use the drying rack, the drum continues to turn, but the rack
remains stationary.
The drying rack is intended for use with the Timed Dry
cycles only. The drying rack cannot be used with
Sensor cycles.
To use the drying rack:
iMPOrTANT: Do not remove the lint screen.
1. Open dryer door.
3. Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does
not move, but the drum will rotate. Make sure items do
not hang over the edges or between drying rack grille.
4. Close the door.
5. Select a Timed Dry/Air Only, or Low Temperature cycle.
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using the Air Only setting.
6. When the cycle is selected, the Estimated Time
Remaining display shows the default time. You can
change the actual time in the cycle by increasing or
decreasing the cycle time.
7. Start the dryer.
NOTe: Check the lint screen and remove any lint
accumulated from items dried on the drying rack
after the cycle is finished.
CYCLE STATUS INDICATORS
+
-
temp level dryness level damp signal
The Cycle Status Indicators show the progress of a cycle.
Check lint Screen
The Check Lint Screen indicator will light when the dryer
is turned on as a reminder to clean the lint screen before
each load.
Sensing
The Sensing indicator will light during Sensor Cycles to
indicate that the moisture sensor on the dryer is operating.
This indicator will not light during Timed Cycles or options
such as Wrinkle Prevent ™ .
Wet
The load is still wet and/or the cycle just started.
damp
This indicator shows that the load is partially dried and items
that you may wish to hang up or iron while still damp may
removed.
Cool down
The dryer has finished drying with heat, and is now tumbling
the load without heat to cool it down and reduce wrinkling.
Steam (on some models)
This indicator will light when the Steam Boost function
is active. NOTe: Steam is not available on all models or
on all cycles.
reduce Static (on some models)
This indicator will light when the Reduce Static function is
active. NOTe: Reduce Static is not available on all models
or on all cycles.
done
This will indicate that the selected cycle has ended and the
load may be removed from the dryer. If the Wrinkle Prevent
option has been selected, the dryer may continue to tumble
the load, even if the Done indicator is lit.
Wrinkle Prevent ™
This indicator will light if the Wrinkle Prevent option has been
selected and is running. The dryer will continue to tumble
the load for up to 150 minutes (depending on model and
selected settings) after the cycle has ended.
11-cycle model shown