Miller Electric OM-842 - Manuel (Page 16)

OM-842 Page 12
SECTION 3 – OPERATION
3-1. Controls
1 Voltmeter
2 Ammeter
3 Digital Display
4 Left/Decrease Button
5 Right/Increase Button
6 Parameter Select Button
7 Purge Button
8 Mode Switch
9 Program/Run/Reset Keyed
Switch
10 Remote Pendant
Ref. ST-162 479-A / Ref. ST-146 839
1
2
3 4 5 6 7 8
9
10
3-2. Safety Equipment
Wear the following while welding:
1 Dry, Insulating Gloves
2 Safety Glasses With Side
Shields
3 Welding Helmet With Correct
Shade Of Filter (See ANSI
Z49.1)
sb3.1 1/94
1 2 3
3-3. Work Clamp
1 Work Clamp
Connect work clamp to a clean,
paint-free location on workpiece, as
close to weld area as possible.
Use wire brush or sandpaper to
clean metal at weld joint area. Use
chipping hammer to remove slag
after welding.
sb4.1 2/93
Tools Needed:
1