Maytag W10267631A-SP - Manuel (Page 14)

14
6. Hang door by placing screw heads into top slotted holes
of hinges and slide door down. Align bottom screw holes
in hinge and door. Install two bottom screws. Tighten
all hinge screws.
7. Close door to engage door strike.
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer Operation
Dryer will not run
■ Has a household fuse blown, or has a circuit breaker
tripped?
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
■ Is the correct power supply available?
Electric dryers require 240-volt power supply. Check with
a qualified electrician.
■ Was a regular fuse used?
Use a time-delay fuse.
No heat
■ Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Dryer displaying code message
■ “PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START/PAUSE to restart the dryer.
Try the following:
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses
or breakers. Replace the fuse or reset the circuit breaker.
Confirm the power cord is properly installed.
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.
■ “F” Variable (F1E1, F2E2, F3E1, F3E2, F7E1, F3E6, F3E7)
service codes:
Call for service.
■ For all models without a display window:
If the “WET” indicator light is flashing and all other display/
indicator lights on the control panel are off:
Call for service.