GE GBC12 - Manuel (Page 11)

Installation Instructions
11
INSTALL CENTER HINGE ON THE LEFT
Remove the two plug buttons on the left side and
install them on the right. Remove the mullion
screw and screw cover on the left side with a
Phillips screwdriver and install on the right.
Rotate the center hinge and shim(s) 180 degrees
and install on the left side as shown. Make sure
that the hinge pin inserts into the hole in the top
of the freezer door.
Tighten the screws and remove the tape holding
the door shut.
CAUTION:
When assembled correctly,
the hinge is tight against the cabinet.
ATTENTION: The screws must be properly tightened.
Turn the screws until snug. Then tighten the screws a
minimum of 1/2 turn using both hands.
7 REHANG THE FRESH FOOD DOOR
Using a 3/8" socket driver, remove the nut and
locking washer that is holding the top hinge pin in
place. Once removed, insert the threaded part of
the hinge pin through the opposite side of the
hinge bracket (thereby reversing the top hinge).
Secure the hinge pin in the bracket by installing
the locking washer and tightening the nut.
Place the fresh food door onto the center hinge,
close the door, MAKE SURE IT IS PROPERLY
ALIGNED, and tape it in place with masking tape.
Install the top hinge on the left side so that the
hinge pin inserts into the hole in the top of the
fresh food door. Tighten the bolts, ensuring that
the door is level and aligned properly.
Transfer the other hinge cover to the right side
and secure with bolts.
8
INSTALL TOP COVER
Re-install the top cover, sliding it into place and
securing with the 5 original screws.
9
A
B
C
A
B
A
B
C
D
E
REVERSING THE HANDLES
Follow instructions for installing the Handles
(page 8) for the right side.
Transfer the plug buttons from the right side to
the left side to cover the holes.
10
A