GE GBC12 - Manuel (Page 10)

INSTALLING THE DOOR STOPS
With the doors laying on a non-scratching
surface, remove the door stop from the bottom of
each door using a Phillips screw driver.
Retrieve new door stops from the accessory bag.
Install new door stop on the opposite side of each
door by fully inserting the pin into the hole in the
door. You may have to clear the hole of insulation
foam using a screw driver. Secure each door stop
in place with the screw provided.
4
Installation Instructions
REVERSING THE DOOR SWING
(CONT.)
REMOVE THE FREEZER DOOR
Tape the door shut with masking tape.
Remove the center hinge and shim(s) by removing
the screws. Be sure to keep the shim(s).
Remove the tape and lift the door off the bottom
hinge pin.
Set the door on a non-scratching surface.
CAUTION:
Do not let door drop
to the floor.
3
10
TRANSFER BOTTOM HINGE
TO THE LEFT
Remove the bottom hinge bolts with a 5/16"
socket driver. Discard the hinge to the accessory
bag, saving the shim(s).
Using a flat blade screw driver, remove the
bottom hinge hole covers from the left side and
transfer to the right side.
Retrieve a new bottom hinge from the accessory
bag and install the new hinge and shim(s) on the
left side. Do not tighten the bolts completely.
5
REHANG THE FREEZER DOOR
Place the freezer door on the bottom hinge, close
the door, MAKE SURE IT IS ALIGNED PROPERLY,
and tape it in place with masking tape.
Tighten the bottom hinge bolts completely,
ensuring that the door is level and aligned
properly.
6
C
D
B
A
A
B
C
A
B
C
A
B