Eagle Pump & Compressor Portable Electric/Gas Compressor - Manuel (Page 8)

6
HOW TO INSTALL NEW BELT IF REQUIRED
1. Disconnect power supply.
2. Remove belt guard.
3. Loosen motor bolts and slide motor toward compressor head just
enough to allow old belt to be removed.
4. Install proper replacement belt.
5. Slide motor away from compressor head to provide recommended
tension as shown in diagram on page 5.
6. Align belt using a straight edge ruler against pulley’s edge.
7. Fasten motor bolts.
8. Ensure motor and compressor pulley’s are secure. Re-check alignment.
9. Re-install belt guard and reconnect power supply.
10.Belt tension should be checked after 20 hours of operation. Check
tension monthly thereafter.
OPERATING YOUR AIR COMPRESSOR
A) ENGINE GAS DRIVEN (continous run only)
1) Check entire unit for any damage.
2) Check compressor and engine oil level, fill or add if necessary.
3) Make sure gas tank is filled.
4) Read entire engine manual.
5) Starting the engine.
a) Move fuel lever to the "On" position.
- If engine is cold, move choke lever to the "Closed" position
- If engine is warm, leave choke lever in "Open" position
b) Turn engine switch to "On" position.
c) Pull starter grip lightly until you feel resistance, then pull briskly,
return starter grip gently - engine should start, if not repeat.
d) Once the engine starts running, slowly move the choke lever
to the "Open" position.
e) With the engine running properly, the compressor fills the air
receiver with compressed air, when maximum pressure (set by the
pilot valve control) is reached, the engine and compressor will slow
down to idle speed, and will return to full RPM when the cut-in
pressure is reached. The unit will continue to cycle automatically
until turned off.
6) Stopping the engine.
a) Turn engine switch to the "Off" position.
b) Turn the fuel lever to the "Off" position.
ENGINE IDLE SPEED MAY NEED TO BE
ADJUSTED, EVEN ON YOUR BRAND
NEW UNIT TO COMPENSATE FOR
DIFFERENCES IN ALTITUDE. PLEASE CONSULT
THE ENGINE OPERATING MANUAL.