Eagle Pump & Compressor Portable Electric/Gas Compressor - Manuel (Page 5)

NEVER WELD, DRILL OR CHANGE THE
AIR RECEIVER IN ANY WAY.
Any replacement parts should be purchased with the same specifications as
the original equipment. Please contact the authorized dealer for
replacement parts or specifications.
SAFETY VALVE
This valve is factory installed to prevent over pressurizing of the air receiver.
It is factory set at a specific limit for your particular model, and should never
be tampered with.
Adjustment by user will automatically void the warranty.
DO NOT REMOVE, MAKE
ADJUSTMENTS TO OR SUBSTITUTE
THIS VALVE!
INSTALLATION
1. INSTALLATION
Proper care, maintenance and lubrication ensures longevity. The compressor
should always be level for proper lubrication. Do not over tighten foot bolts
as excessive vibration may occur. Use only in a clean, dry, and well-ventilated
area. The compressor has heat dissipation fins for proper cooling. Keep the
fins and other parts that collect dust clean. Do not place rags or other
materials on top of the compressor, as this obstructs cooling and can be a
fire hazard.
2. BREAK-IN PROCEDURE
1. Open the air receiver's drain valve or outlet valve.
2. Run the compressor for a minimum of twenty (20) minutes in no-load
condition to lubricate the bearings and pistons.
3. Close the air receiver drain valve and the outlet valve. Your compressor is
now ready for use.
4. Check v-belt for proper tension after 24 hours of operation. (see item 10.)
5. Nuts and bolts may loosen, retighten when necessary.
6. Compressor oil may turn black. This is normal, change after 100 hours.
3