Installation of the washer, Safety and precautions – Curtis RPW302 Manuel d'utilisation

Page 5

Advertising
background image

7

Please use correct power source.

Please do not pull out or insert the
plug with wet hands to avoid electric
shocking.

Please ensure that the water inlet pipe
is connected and the tap is opened
before washing
clothes.

Customers are not allowed to change
the power line without permission.

It is strictly prohibited to place and sit
children or lay
weights on the
washer.

Please do not pull the electric cord
when pulling out the
plug.

Please do not wash down raincoat,
fishing coat and similar
clothes in the
washer.

!

!

!

+

+

>55

C

The water temperature shall not exceed
55℃ when washing
with warm water.

Prohibited

Prohibited

Prohibited

Prohibited

Caution

8

Installation of the washer

Remove package

! Remove package and take out the bottom board of

the cabinet on the foam cover.

! Open the lid of washer's door and take out accessories.

! A trial operation or washing on the foamed cushion is

strictly forbidden.

Base foamed cushion

The height of drain hose (“a”)should between 86-100 cm.
Diameter of “b”shuld not less than 3 cm, and flow capacity
not less than 40 L/Min.

86~100 cm

Placement of upper water drain hose

Before washing machine starts, user should hang up the
drain pipe 86-100cm height from the floor.

Installation of water inlet pipe

Put the water inlet pipe(which has

metallic filtering bag) screw on to the tap.
Tightly screw another end of water
inlet hose on water inlet valve .
(with rubber seal ring inside).
Note: When tightening the

evenly apply the force and do not twist

the water inlet valve to avoid breaking of

water inlet valve joint.

clamping nut,

Water inlet hose

Clamping nut

If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.

The instructions for appliances connected to the water mains by detachable

hose-sets shall state that the new hose-sets supplied with the appliance are

to be used and that old hose-sets should not be reused.

The openings must not be obstructed by a carpet.This appliance is for indoor use only.
When choosing the water inflowing to wash tub or spin tub , please do not move
the water inlet valve during the process of water inflowing.
If strong vibration occurs in time of spinning, open the spin cover immediately.
Make sure that the washing machine is placed on a flat and stable floor ,and then
adjust washing materials, distribute them evenly.
To do spinning and draining together, please spin for 1 minute before draining.
Do not wash or spin waterproof clothes or clothes that float easily to avoid abnormal
vibration or damage to the clothes.

Wet hands are
prohibited

Safety and precautions

Safety and precautions

Advertising